Cảm Biến Quang Điện Banner Q08

(1 đánh giá)

Banner Q08


12 Tháng

Công Ty TNHH Kỹ Thuật Điện Hiệp Lực Mr Bình:TEL:0905 496 424- 0903 743 151 Email: dhl.sale04@gmail.com Skype: dhl.sale04 YaHoo: thanhbinh850036

Supply Voltage and Current 10 to 30V dc (10% max. ripple) Opposed:50 mA total max. (exclusive of load)
Emitter:30 mA (exclusive of load)
Receiver:25 mA (exclusive of load)
Diffuse:25 mA (exclusive of load)
Range Opposed:510 mm
Diffuse:2.5 to 60 mm
Supply Protection Circuitry Protected against reverse polarity and continuous overload or short circuit
Output Configuration SPST solid-state switch:NPN (current sinking) or PNP (current sourcing), depending on model. Light operate (LO) or dark operate (DO), depending on model
Output Rating 150 mA max., continuous OFF-state leakage current:100 µA @ 30V dc
ON-state saturation voltage:less than 200 mV @ 10 mA dc; less than 1 V @ 150 mA dc
Output Protection Circuitry Protected against false pulse on power-up
Output Response Time 1 millisecond ON/OFF, independent of signal strength
Repeatability 200 microseconds, independent of signal strength
Indicators 2 LED Indicators:Green and Yellow
Green ON steady:power to sensor is ON
Yellow ON steady:lights when sensor output is conducting (in light condition for light-operate models; in dark condition for dark-operate models)
Construction Black epoxy-painted die-cast zinc housing, polysulfone thermoplastic lens with two through-mounting holes to accommodate M3 (#4) hardware
Environmental Rating IEC IP67; Meets NEMA standards 1, 2, 4, 6 and 13
Connections 2 m or 9 m attached PVC cable, or 3-pin Pico-style quick-disconnect fitting. QD cables are ordered separately.
Operating Conditions Temperature:0° to 50° C
Relative humidity:90% @ 50° C (non-condensing)
Application Note Be aware that optimum mechanical alignment of Q08 emitter/receiver pairs may not always result in optimum optical alignment. This may be a factor at longer sensing ranges. Once optimum mechanical alignment has been achieved, optical alignment can be optimized by tilting one unit (emitter or receiver) up/down and left/right. Look for center of the movement zone within which the receiver's output remains in the desired output state: ON for light-operate units and OFF for dark-operate units.

Đánh giá sản phẩm

Bình chọn sản phẩm:

Bình luận

Sản phẩm cùng loại

Sản Phẩm Giảm Giá

Hổ trợ trực tuyến

Hotline: Mr Duy

Hotline: Mr Duy - 0946.733.151

MR. Bình

MR. Bình - 0903.733.151

Liên kết website

Thống kê

  • Đang online 28
  • Hôm nay 110
  • Hôm qua 1,086
  • Trong tuần 1,196
  • Trong tháng 36,010
  • Tổng cộng 1,870,524